Lesson 2 · Grade 7 · 40 minutes

Custom Six-Sided Die

Engrave six faces and turn a simple cube into a die with its own rules.

A purple die with recessed pips on its visible faces

What you’ll make

A rounded 30 mm cube with six engraved faces, flat landing surfaces, and a clear rule for using it.

You’ll need

Tinkercad, pencil, paper, and a sample die

Teacher preparation

Have a numbered die and an engraved face ready to show. Let students use digits 1–6 as the fast build. Share the three face pairs before modeling.

0–4 minPlan

Give your die a purpose

  1. Roll a sample die. Decide what each roll should do in your design. Try numbers for a board game, short prompts for an activity, or symbols for a decision.
  2. Sketch your six faces in three opposite pairs. On a standard number die, the pairs are 1 and 6, 2 and 5, and 3 and 4. Each pair totals 7.

4–9 minModel

Build a rounded cube

  1. Create a 30 × 30 × 30 mm Box. Set Radius to 2 and Steps to 10. Check that each face still has a flat area.
  2. Press D to put the cube on the ground workplane. Keep a spare copy if you want a quick reset.

9–16 minModel

Engrave your first face

  1. Use W to put the Workplane on the top face. Add a digit or letter with Text, size it to fit in the center, and set its thickness to 2 mm.
  2. Switch the mark to Hole. Press D to seat it on the face, then lower it 0.8 mm into the cube with the lift handle. The bottom reads −0.8 mm on the face workplane.
  3. Group the cube and the Hole. Check that the mark is recessed. Tick off this face on your plan.

16–29 minBuild

Repeat for all three opposite pairs

  1. Before each turn, use W on the blue grid to restore the ground workplane. Select the whole die and rotate it about a horizontal axis. Press D to put it back on the ground, then use W on the new top face.
  2. Flip 180° for the first opposite face. Rotate 90° on the same axis to find a blank face for the second pair, then flip 180° for its opposite. Use the other horizontal axis for the last pair. Check that the face is blank before you engrave.
  3. Use the same 2 mm cutter and 0.8 mm cut depth each time. For pips, use Hole cylinders about 3.5 mm wide and duplicate them. Group the cuts and check off each face before turning again.

29–36 minTest

Inspect all six faces

  1. Use the ViewCube to inspect every face. Check that all six have readable, recessed marks. If you made a number die, confirm each opposite pair.
  2. Ask a partner to check the six-face plan and explain your rule back to you. Fix one unclear or missing face.

36–40 minSubmit

Export the finished die

  1. Select only the finished die and export an STL. Keep the editable Tinkercad design.
  2. Tell a partner what to do on one roll. Test the flat faces and readability after printing.