Lesson 4 · Grade 7 · 40 minutes

Practical Pen Holder

Measure real stationery, hollow out a solid shape, and check that your design is easy to use.

An open gold pen holder with pens and a ruler

What you’ll make

An open-top holder with 3 mm walls, a closed flat bottom, and room to insert and grab the tools you measured.

You’ll need

Tinkercad, a millimeter ruler, stationery, and sketch paper

Teacher preparation

Have two or three pieces of stationery, including a short item, and a millimeter ruler for each group. Have one correct model ready to inspect from the top and bottom.

0–6 minPlan

Measure what the holder needs to fit

  1. Measure the length and widest part of two or three pens or a ruler. The inside depth is 72 mm. Estimate how much of each tool would stick out.
  2. Sketch an open holder for the items you can reach easily. Decide whether a divider would help or make the opening too narrow.

6–11 minModel

Make the solid outer box

  1. Use the ground workplane and put the Ruler at the lower-left corner. Add a solid Box at (0, 0) with bottom Z = 0.
  2. Set the outer size to 66 × 66 × 75 mm. Check the width, depth, and height before making the cavity.

11–20 minModel

Cut an open top and keep a closed bottom

  1. Add a 60 × 60 × 75 mm Box and turn it into a Hole. Center it on the solid box in X and Y with Align, or put its lower-left corner at X = 3 and Y = 3.
  2. Raise the Hole to Z = 3 mm. Its top is then at Z = 78 mm, above the rim at Z = 75 mm.
  3. Select both shapes and group them. Inspect the opening and turn the model over. There should be four 3 mm walls and a 3 mm solid floor.

20–26 minBuild

Choose one functional improvement

  1. If your design needs two compartments, add a 60.4 × 3 × 72 mm solid divider at X = 2.8, Y = 31.5, and bottom Z = 2.8 mm. It overlaps the floor and both side walls by 0.2 mm. Each opening will be 60 × 28.5 mm.
  2. A single compartment is a complete design. If you add a name or flat mark, attach it to the outside of a wall. Keep the opening and underside clear.

26–35 minTest

Check fit, grip, and stability

  1. Model one measured pen with a cylinder, or a ruler with a thin box. Place the separate test shape upright with its bottom at Z = 3 mm.
  2. Look from above and from the side. Check that the tool clears the walls and divider, and that enough sticks out to grab. Look underneath for a flat, closed bottom.
  3. Exchange designs with a partner. Check the opening, reach, flat bottom, and all part connections. Fix the problem that matters most in use.

35–40 minSubmit

Export and plan a real fit test

  1. Remove the virtual stationery, then group all connected holder parts. Save the Tinkercad design and export only the holder as an STL.
  2. After printing, insert and remove the real stationery. Test whether the loaded holder stays upright and the tools are easy to grab.